eth0 and camera (serial port) configuration in FC3

[Ankush Grover]

hey,

if your using gui run the command "neat" .It will show you the 
network cards add the ipaddress ,dns entries and hostname and then
activate it .If it does not activate ,it will show some error at that
time .

Post that error over here .Morever try this command "ifconfig -a " it
will show all the network interfaces.

Regards

Ankush

On Sun, 13 Feb 2005 21:47:16 -0800, Jeff Trefftzs <trefftzs at tcsn.net> wrote:
> Hi all -
> serial camera
> I have just upgraded from RH 9 to FC 3 and gotten most of my stuff
> working with two notable exceptions:  I cannot seem to get my local
> network working again (eth0 - the latest problem is it can't find an IP
> address), nor can I get access to my serial port digital camera.  gthumb
> lets me try to configure it, but I keep seeing the message "Can't
> activate camera".
> 
> I expect it's something relatively simple -- possibly in my lack of
> understanding of the new udev device handling.  Can somebody please walk
> me through the steps needed to configure and activate my ethernet
> connection and the same for the serial port for the camera?  Both worked
> just fine under RH 9.
> 
> Thanks in advance,
> 
> --
> Jeff
> 
> --
> fedora-list mailing list
> fedora-list at redhat.com
> To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
>