trouble installing printer driver

[Riku Seppälä]

Paul Howarth wrote:

> Riku Seppälä wrote:
>
>> I'm running FC3. I have lexmark p3150 printer, cups doesen't have 
>> driver for it. I found driver from here: 
>> http://users.cybercity.dk/~dko12479/
>> Installed the z700llpddk-2.0-1.i386.rpm 
>> <http://users.cybercity.dk/%7Edko12479/z700llpddk-2.0-1.i386.rpm> 
>> with no problem, but can't install the 
>> lexmark-z700-cups-driver-1.1.1-1.i586.rpm 
>> <http://users.cybercity.dk/%7Edko12479/lexmark-z700-cups-driver-1.1.1-1.i586.rpm>: 
>>
>> error: Failed dependencies:
>>        libcrypto.so.0.9.7 is needed by 
>> lexmark-z700-cups-driver-1.1.1-1.i586
>>        libssl.so.0.9.7 is needed by 
>> lexmark-z700-cups-driver-1.1.1-1.i586
>>
>> I made the sympolic links just like it was suggested on the page, but 
>> it changed nothing.  Any advice?
>
>
> Remove the links you made, which are a horrible hack and may cause 
> confusion later. The problem you are having is that the package was 
> built against openssl-0.9.7 whereas FC3 includes openssl-0.9.7a, which 
> has a slightly different (and not fully compatible) interface.
>
> If you follow the "Source installation" instructions, you should end 
> up with a version that is compatible with FC3.
>
> Paul.
>
OK, I removed the links. Tried the source installation, there is no 
configure just makefile. I did make, make install, everything looked ok. 
But printer configuration don't show any new lexmark models. Maybe I'm 
missing something.. have to check everything again.

Riku Seppälä