OT? power reqs of DDR2 chips
Wolfgang S. Rupprecht
wolfgang.rupprecht+gnus200705 at gmail.com
Tue May 22 03:50:25 UTC 2007
Dave Stevens <geek at uniserve.com> writes:
> I'm building a new box that will use a DDR2 2G reg/ECC chip. I need to
> estimate power draw for the system and can't seem to find a reference. Its
> Kingston Value Ram, if that matters. The box _will_ run Fedora.
I hate to give such a non-answer, but the power consumption is so
highly determined by your usage pattern that you really can't do
anything but try it and measure using a very low impedance meter.
When running block-moves you'll probably see around 2watts per
actively accessed chip. Fedora just sitting around will consume quite
a bit less. The power will probably be dominated by the termination
resistors of ~150mw per chip, which will be your ultimate lower bound.
-wolfgang
--
Wolfgang S. Rupprecht http://www.wsrcc.com/wolfgang/
Hints for IPv6 on FC6 http://www.wsrcc.com/wolfgang/fedora/ipv6-tunnel.html
More information about the users
mailing list