Adding Drivers to the Live CD.
nathan.woodruff at igovincent.com
Thu Jul 24 19:07:05 UTC 2008
I've worked with Alan all afternoon long and I have used linux s to get to a
prompt. But now I am having issues copying the data off now that I can see
the actual data.
I have nowhere to copy it to as in I can get into the box but I can't copy
the data to another device because there is no other device that this kernel
From: fedora-list-bounces at redhat.com [mailto:fedora-list-bounces at redhat.com]
On Behalf Of Todd Denniston
Sent: Thursday, July 24, 2008 2:36 PM
To: For users of Fedora
Subject: Re: Adding Drivers to the Live CD.
Nathan Woodruff wrote, On 07/24/2008 11:15 AM:
> I have a U2 server running Fedora. It has 4 500GB drives on an Adaptec
> Raid 2420SA card. Last week we had a power failure over night. The UPS's
> for about 2 hours and then POOF no power. None of us even though about
> checking on the servers that night. When our company finally got power the
> next morning, the Fedora server would not boot completely.
> It runs the usual list of things that are okay and one or two that Failed.
> But it comes to a blank line and halts. I can't get a bash prompt.
By this you mean you are seeing init starting daemons? i.e.,
starting eth0 [OK]
> This server has some data we need to get off before we reformat the entire
> thing and start again.
> I've downloaded the Live CD and booted it but it doesn't recognize our
> drives. I would take the drives out and read them individually but the 4
> drives have been raided into one large drive and would be useless trying
> read each individual drive.
Linux software RAID, or some Adaptec proprietary hard/soft RAID?
> I need to add Adaptec's driver to the Live CD to be able to recover this
> data. But every tool that I have available to me can not read the .IMG
> on the Live CD in order to add Adaptec's Raid driver.
perhaps you could load the driver AFTER the live CD is up to runlevel 3|5
> Any help???
Assuming init is kicking daemons, then as the boot switches from the kernel
init, IIRC you can enter an 'I' for interactive and OK init to start each
daemon individually. If you can get in this mode you could maybe have init
skip the two that fail and the one where the blank line and halt happen.
it might also help to know WHAT daemon is failing.
otherwise you are back to what Alan indicated.
Crane Division, Naval Surface Warfare Center (NSWC Crane)
Harnessing the Power of Technology for the Warfighter
fedora-list mailing list
fedora-list at redhat.com
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
More information about the users