mounting one usb interface (from 2 identified)

[Ranjan Maitra]

On Fri, 23 Nov 2012 12:07:01 +0800 Ed Greshko <Ed.Greshko at greshko.com>
wrote:

> On 11/23/2012 11:30 AM, Ranjan Maitra wrote:
> > On Fri, 23 Nov 2012 11:17:47 +0800 Ed Greshko <Ed.Greshko at greshko.com>
> > wrote:
> >
> >>
> >> Are you saying you don't have an sdb1 or sdc1?
> >>
> >> If the device you have is a storage device which has partition table defined it you should get /dev/sdbX (where X is an integer).  If you're not getting this, the device doesn't have a valid partition table.
> > Yes, this is correct. Any suggestions then?
> >
> 
> As root.....(example below for my USB thumb drive)
> 
> [root at meimei ~]# parted /dev/sdb
> GNU Parted 3.0
> Using /dev/sdg
> Welcome to GNU Parted! Type 'help' to view a list of commands.
> 
> (parted) print    <----user input
>                                                           
> Model: Ut165  (scsi)
> Disk /dev/sdg: 2022MB
> Sector size (logical/physical): 512B/512B
> Partition Table: loop
> Disk Flags:
> 
> Number  Start  End     Size    File system  Flags
>  1      0.00B  2022MB  2022MB  fat32
> 
> (parted) quit          <----user input            
> 

Thanks again! Same story....

sudo parted /dev/sdb
Error: Error opening /dev/sdb: No medium found
Retry/Cancel?                                                             

Many thanks and best wishes!
Ranjan

____________________________________________________________
Receive Notifications of Incoming Messages
Easily monitor multiple email accounts & access them with a click.
Visit http://www.inbox.com/notifier and check it out!