Camera panasonic-TZ18

Patrick Dupre pdupre at gmx.com
Wed Jul 31 23:08:52 UTC 2013


Thank,

Here it is 

The camera says connexion to PC in progress, and it takes a very long time before it disappears.

In addition, if I try to add the camera manually from digikam, there is not model showing up.
It looks like that I need to install some drivers.


Aug  1 01:00:02 sophocle systemd-udevd[11100]: inotify_add_watch(7, /dev/sdb, 10) failed: No such file or directory
Aug  1 01:00:07 sophocle kernel: [11896.611096] usb 1-6: new high-speed USB device number 7 using ehci-pci
Aug  1 01:00:07 sophocle kernel: [11896.728118] usb 1-6: New USB device found, idVendor=04da, idProduct=2372
Aug  1 01:00:07 sophocle kernel: [11896.728127] usb 1-6: New USB device strings: Mfr=1, Product=2, SerialNumber=3
Aug  1 01:00:07 sophocle kernel: [11896.728131] usb 1-6: Product: DMC-TZ18
Aug  1 01:00:07 sophocle kernel: [11896.728135] usb 1-6: Manufacturer: Panasonic
Aug  1 01:00:07 sophocle kernel: [11896.728138] usb 1-6: SerialNumber: 0000000000000000006F1302150801
Aug  1 01:00:07 sophocle kernel: [11896.728801] usb-storage 1-6:1.0: USB Mass Storage device detected
Aug  1 01:00:07 sophocle kernel: [11896.733248] usb-storage 1-6:1.0: Quirks match for vid 04da pid 2372: 90
Aug  1 01:00:07 sophocle kernel: [11896.735270] scsi5 : usb-storage 1-6:1.0
Aug  1 01:00:07 sophocle mtp-probe: checking bus 1, device 7: "/sys/devices/pci0000:00/0000:00:1d.7/usb1/1-6"
Aug  1 01:00:07 sophocle mtp-probe: bus: 1, device: 7 was not an MTP device
Aug  1 01:00:08 sophocle kernel: [11897.738193] scsi 5:0:0:0: Direct-Access     MATSHITA DMC-TZ18         0110 PQ: 0 ANSI: 2
Aug  1 01:00:08 sophocle kernel: [11897.738800] sd 5:0:0:0: Attached scsi generic sg2 type 0
Aug  1 01:00:08 sophocle kernel: [11897.740008] sd 5:0:0:0: [sdb] Adjusting the sector count from its reported value: 15523840
Aug  1 01:00:08 sophocle kernel: [11897.740054] sd 5:0:0:0: [sdb] 15523839 512-byte logical blocks: (7.94 GB/7.40 GiB)
Aug  1 01:00:08 sophocle kernel: [11897.741035] sd 5:0:0:0: [sdb] Write Protect is on
Aug  1 01:00:08 sophocle kernel: [11897.741890] sd 5:0:0:0: [sdb] No Caching mode page present
Aug  1 01:00:08 sophocle kernel: [11897.741898] sd 5:0:0:0: [sdb] Assuming drive cache: write through
Aug  1 01:00:38 sophocle kernel: [11928.101092] usb 1-6: reset high-speed USB device number 7 using ehci-pci
Aug  1 01:01:09 sophocle kernel: [11959.109182] usb 1-6: reset high-speed USB device number 7 using ehci-pci
Aug  1 01:01:41 sophocle kernel: [11990.213151] usb 1-6: reset high-speed USB device number 7 using ehci-pci
Aug  1 01:02:11 sophocle kernel: [12021.189094] usb 1-6: reset high-speed USB device number 7 using ehci-pci
Aug  1 01:02:12 sophocle kernel: [12021.312222] sd 5:0:0:0: [sdb] Adjusting the sector count from its reported value: 15523840
Aug  1 01:02:12 sophocle kernel: [12021.313518] sd 5:0:0:0: [sdb] No Caching mode page present
Aug  1 01:02:12 sophocle kernel: [12021.313525] sd 5:0:0:0: [sdb] Assuming drive cache: write through
Aug  1 01:02:42 sophocle kernel: [12052.165207] usb 1-6: reset high-speed USB device number 7 using ehci-pci
Aug  1 01:03:13 sophocle kernel: [12083.141074] usb 1-6: reset high-speed USB device number 7 using ehci-pci
Aug  1 01:03:44 sophocle kernel: [12114.117204] usb 1-6: reset high-speed USB device number 7 using ehci-pci
Aug  1 01:04:15 sophocle kernel: [12145.157208] usb 1-6: reset high-speed USB device number 7 using ehci-pci


> ----- Original Message -----
> From: Ed Greshko
> Sent: 08/01/13 01:02 AM
> To: Community support for Fedora users
> Subject: Re: Camera panasonic-TZ18
> 
> On 08/01/13 06:55, Patrick Dupre wrote:
> > I connected my camera panasonic DMC-TZ18
> > Bus 001 Device 005: ID 04da:2372 Panasonic (Matsushita) Lumix Camera (Storage mode)
> >
> > but it does not seem to be seen by the computer.
> > no camera been by digicam or shotwell.
> > Do I need to install some drivers?
> 
> Watch /var/log/messages as you plug it in. Sounds as if it may be to be accessed as a USB drive.
> 
> -- 
> Getting tired of non-Fedora discussions and self-serving posts
> -- 
> users mailing list
> users at lists.fedoraproject.org
> To unsubscribe or change subscription options:
> https://admin.fedoraproject.org/mailman/listinfo/users
> Fedora Code of Conduct: http://fedoraproject.org/code-of-conduct
> Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
> Have a question? Ask away: http://ask.fedoraproject.org


===========================================================================
 Patrick DUPRÉ                                 | | email: pdupre at gmx.com
 Laboratoire de Physico-Chimie de l'Atmosphère | |
 Université du Littoral-Côte d'Opale           | |
 Tel.  (33)-(0)3 28 23 76 12                   | | Fax: 03 28 65 82 44
 189A, avenue Maurice Schumann                 | | 59140 Dunkerque, France
===========================================================================


More information about the users mailing list