qcad

[Patrick Dupre]

Thank Richard,

Is librecad srpm available somewhere?
The bad thing with qcad is that runiing from a remote machine (fedora 18) it
even kill the local fedora 20 session!!
Why that?

I also tried FreeCAD, but my dxf files seem to be barely compatible.
I even cannot get the font displyed!

> > >
> > > > > Without specifics I don't even know if the situation is different
> > > > > now with
> > > > the 3.X releases. If LibreCAD is a good replacement then there may be
> > > > no point.
> >
> >
> > Are the librecad and qcad library compatible?
> >
> > Why librecad is not offered in the fedora distribution?
> > I tried to installed it from the librecad website, but I failed:
> >
> > Packages skipped because of dependency problems:
> > librecad-2.0.0-1.1.i686 from /librecad-2.0.0-1.1.i686
> 
> 
> LibreCAD has been accepted into Fedora but Spot has not done any builds (or
> checked anything in) so I pulled the last SRPM from the Review Request[1]
> and built it. I could only test over remote X11 right now but it seems to
> work.
> 
> Richard
> 
> [1] https://bugzilla.redhat.com/show_bug.cgi?id=950171


===========================================================================
 Patrick DUPRÉ                                 | | email: pdupre at gmx.com
 Laboratoire de Physico-Chimie de l'Atmosphère | |
 Université du Littoral-Côte d'Opale           | |
 Tel.  (33)-(0)3 28 23 76 12                   | | Fax: 03 28 65 82 44
 189A, avenue Maurice Schumann                 | | 59140 Dunkerque, France
===========================================================================