Ethernet card does not work with FC2

[Andrea Marin]

But when you lunch as root:

#ifconfig eth0

what happen?

If there is your network-interface whit the same parameter for the
ip-address and mac-address is right.

But the service network is started?
/etc/rc.c/init.d/network status

the answer maybe is like this

Configured devices:   
lo eth0
Currently active devices:
lo eth0

If is like this is right, if in the Currently active devices there is
only the loopback-interface it seams that your network is down and you
must bring up whit the command :

/etc/rc.c/init.d/network start 

Now you can try to ping yourself whit the IP-Address of your intranet
and after you can try to ping the other machines.

Bye Andrea

On Wed, 2004-07-21 at 13:14, Alberto M R Davila wrote:
> Thanks Andrea,
> 
> My "ifcfg-eth0" is like this:
> 
> # Intel Corp.|82801BA/BAM/CA/CAM Ethernet Controller
> DEVICE=eth0
> BOOTPROTO=static
> BROADCAST=XXX.XXX.XXX.XXX
> HWADDR=00:00:39:DE:29:3F
> IPADDR=XXX.XXX.XXX.XXX
> NETMASK=255.255.255.0
> NETWORK=XXX.XXX.XXX.XXX
> ONBOOT=yes
> TYPE=Ethernet
> USERCTL=no
> PEERDNS=no
> GATEWAY=XXX.XXX.XXX.XXX.
> IPV6INIT=no
> 
> When I "ping" to a machine in the intranet I got this:
> 
> [root at tryps network-scripts]# ping LOCAL.MACHINE
> PING LOCAL.MACHINE (LOCAL.MACHINE) 56(84) bytes of data.
> >From  XXX.XXX.XXX.XXX icmp_seq=0 Destination Host Unreachable
> >From  XXX.XXX.XXX.XXX icmp_seq=1 Destination Host Unreachable
> >From  XXX.XXX.XXX.XXX icmp_seq=2 Destination Host Unreachable
> >From  XXX.XXX.XXX.XXX icmp_seq=3 Destination Host Unreachable
> >From  XXX.XXX.XXX.XXX icmp_seq=4 Destination Host Unreachable
> >From  XXX.XXX.XXX.XXX icmp_seq=5 Destination Host Unreachable
> >From  XXX.XXX.XXX.XXX icmp_seq=6 Destination Host Unreachable
> >From  XXX.XXX.XXX.XXX icmp_seq=7 Destination Host Unreachable
> >From  XXX.XXX.XXX.XXX icmp_seq=8 Destination Host Unreachable
>