Feature request: VLAN balancing

[Bartosz Lis]

Dear "team" developers and users,

Is it possible to configure VLANs, say: VLAN2 and VLAN3 on top of team with 
enslaved interfaces say eth0 and eth1, in such a way, that:

1. when only one interface is up, all the traffic goes through that interface;
2. when both interfaces are up, VLAN2 traffic goes through eth0 while VLAN3 
traffic goes through VLAN3?

This (requested) behaviour is a little bit similar to the bonding mode 1 - 
active/backup. The difference is that there is no single "global" active 
interface, instead each VLAN has its active interface defined irrespective of 
other VLANs. Looking from the side of enslaved interfeces - any given 
interface is not definitely in an active or backup state, but rather, for a 
group of VLANs is active while being in backup state for the other VLANs.

Kind regards,

-- 
Bartosz Lis

[pl] Instytut Informatyki Politechniki Łódzkiej
[en] Institute of Information Technology, Lodz University of Technology
Wolczanska 215
90-924 Lodz, Poland

phone:  [phone]
fax:    [phone]
email:  bartosz.lis(a)ics.p.lodz.pl