On Thu, Mar 08, 2012 at 01:23:02PM +0200, Georgios Petasis wrote:
Στις 8/3/2012 11:30, ο/η Alon Levy έγραψε:
>ok, if the VM runs on a separate pc, of course it doesn't work - I
>wrongly assumed it was on the same pc as virt-manager. You need to
>capture the interface that the spice connection is on - so the
>network connection, which would be em1 / eth0. Wireshark has a
>neat mode where it shows you the packets per interface before
>starting a capture on a specific interface
>(menu->capture->interfaces, or ctrl-i).
Dear Alon,
I am a little confused.
I have a PC. I have started a VNC server on the pc. I run
virt-manager inside this vnc server. I run the VM from this
virt-manager (so virt-manager & VM run in the pc that the vnc server
runs).
And from a second pc, I have a vnc client, that I see all these.
OK, I didn't understand correctly, thanks for the patience.
So this one will be pointless since the spice connection is over
loopback on your headless pc.
So you are using wireshark on the headless PC via VNC? I don't see any
TCP connections being created, as I would expect if virt-manager starter
the spice connection after the capture is started. Can you please make
sure virt-manager is closed before you start the capture?
Regards,
George