RE: koan problem: could not create symlink in /etc/xen/auto

[Joe Linoff]

Hi Scott:
> Is selinux stopping things?

I don't think so. It appears to be disabled. Is there something else I
should check?

dom0 # cat /etc/selinux/config
  # This file controls the state of SELinux on the system.
  # SELINUX= can take one of these three values:
  #       enforcing - SELinux security policy is enforced.
  #       permissive - SELinux prints warnings instead of enforcing.
  #       disabled - SELinux is fully disabled.
  SELINUX=disabled
  # SELINUXTYPE= type of policy in use. Possible values are:
  #       targeted - Only targeted network daemons are protected.
  #       strict - Full SELinux protection.
  SELINUXTYPE=targeted
> Where is it looking for them?

I am not sure. I am still trying to figure it out :-)

Cheers,

Joe

-----Original Message-----
From: Scott Henson [mailto:[e-mail]] 
Sent: Friday, January 07, 2011 8:44 AM
To: Joe Linoff; cobbler mailing list
Subject: Re: koan problem: could not create symlink in /etc/xen/auto

On Thu, 6 Jan 2011 18:08:10 -0800, "Joe Linoff" 
wrote:
> Hi Folks:
>
> I am getting a warning about protections/ownership when I provision 
> domU's using koan and don't know how to fix it. Here is the command 
> that I am using, along with the error message and a listing of the 
> file permissions.

Is selinux stopping things?
> BTW, the domU's seem to be operating just fine but I am having problem
> with convirt (a 3rd party tool) and this might be the cause because it
> can't find the VM configurations.

Where is it looking for them?

--
Scott Henson
Red Hat CIS Operator
WVU Alum BSAE/BSME