I recall you are not using RPM.
On the source side, that is correct. The test server has the RPM
installed. I wanted to try with the RPM first before I attempt any
customizations.
Since you aren't, be sure you ran "cobbler reserialize"
after upgrading.
I just did. No output, is that expected?
Also, I would not expect replication between 1.2.8 and 1.4.3 to work.
Fair enough. This was something I had asked about some time ago and
offered to try. I am only just getting around to it and was wondering
about the python messages. I haven't dug into the source in some time
and wondered if there was an obvious meaning.
I haven't had a chance to verify everything but it looks like the
replication worked despite the initial messages. I have just cleaned up
my cobbler configuration and it is now quite minimal. It wouldn't be too
horrible if I have to start from scratch, but it is nice to know that
replication might be a viable way of restoring the data after I
reinstall each server.
Thanks,
Chris