Hello Ashwith,
here is an example which you can base your work on:
---------------------------------------------------
alter-example
* Two resistance in series
vsig in 0 ac 1 dc 1
res in out 10k
rload out 0 1k
* conducts an ac-response with
* 2 values of load resistor, rload
.ac dec 10 1k 10k
.control
set filetype=ascii
run
plot in out
alter rload = 10k
run
plot v(in) out title alter
write S0.raw v(in)
.endc
.end
---------------------------------------------------
On Thu, Sep 30, 2010 at 5:05 AM, Ashwith Rego <ashwith(a)gmail.com> wrote:
Hi
>From the documentation I understand that in interactive mode, using
the alter command one can change the device parameters. Does this also
mean I can change the values of a resistance or voltage source in the
netlist? If so how? I used the following circuit:
Bridge Rectifier
.options TEMP=25
V2 2 1 SIN(0 vmax 60)
R2 0 3 resistance
D8 1 3 1N4007
D6 2 3 1N4007
D4 0 2 1N4007
D2 0 1 1N4007
.param resistance = 10k
.param vmax = 5
.end
I've tried
alter r2 = 10
alter r2 resistance = 10
But it won't work. How do I alter vmax or resistance?
Thanks
--
Ashwith J. Rego
-----------------
My Webpage:
http://ashwith.wordpress.com/
Find me on LinkedIn at:
http://www.linkedin.com/in/ashwith
Follow Me on Twitter at:
http://twitter.com/Louisda16th
_______________________________________________
electronic-lab mailing list
electronic-lab(a)lists.fedoraproject.org
https://admin.fedoraproject.org/mailman/listinfo/electronic-lab