The symbol creation guide says to add only net designations for power
rails. I didn't find any documentation on the following things I would
need (I think, but I don't know much here):
1. The power rails for bypassing and routing concerns. This means I
need to add caps to the schematic in some fashion.
2. n/c pins. I think they could be treated much like the power pins,
with nc or n/c as the function. Should these be an actual pin listed as
"don't show" or should they be net only like the power pins?
I have put these two topics together, because I believe they are related
in how the schematic software and the PCB software will handle them. I
could be wrong.
Please help, and think about how to document these two issues. I don't
know where they would go, but they should probably be added to the
warmup or tutorial to illustrate a key point about power distribution
and bypassing.
Regards,
Les H
Show replies by date