[PATCH v6 0/3] support dump ssh via link local ipv6 address
When dumping to ssh via local ipv6 address, the ssh parameter
in kdump.conf is supposed to have the form like
ssh user@fe80::cc1:8bff:fe90:b95f%eth0
where "%eth0" is an existing network interface supporting ipv6.
However, there are 3 problems in enabling ipv6:
1) The get_remote_host function in kdump-lib.sh currently
doesn't remove the network interface in the ipv6 address,
causing the ip command in kdump_install_net function to fail,
leading to a "Bad kdump location" message.
2) The kdump_setup_ifname function in dracut-module-setup.sh
would add 'kdump-' prefix to network interfaces with name like
'eth*', causing ssh target specified in kdump.conf invalid
while dumping process.
3) ssh target with 'kdump-' prefixed interface name is not
in known_hosts while dumping, leading to ssh connection failure.
This patch series handles the problems above.
Ziyue Yang (3):
kdump-lib.sh: support link local ipv6 address with interface name
dracut-module-setup.sh: add 'kdump-' prefix in kdump.conf for link
local ipv6
dracut-kdump.sh: support 'kdump-' prefixed interfaces for link local
ipv6
dracut-kdump.sh | 10 +++++++++-
dracut-module-setup.sh | 15 +++++++++++++++
kdump-lib.sh | 11 +++++++++++
3 files changed, 35 insertions(+), 1 deletion(-)
--
2.9.3