On Mon, 3 Jan 2011 12:47:25 -0800, "Joe Linoff" <jlinoff(a)tabula.com>
wrote:
Hi Scott:
Thank you for responding so quickly.
> Does the CentOS 5.5 standard kernel have the correct driver?
I don't think so, running lsmod showed r8169 was installed. According to
the web page (
http://elrepo.org/tiki/tiki-index.php?page=kmod-r8168) it
says I need r8168.
I am not familiar with that particular piece of hardware. Are you able
to connect to the network during the install? Or do you have an
alternative ethernet device that you use for networking during the
install and you need the ethernet driver to access the higher speed
network while the host is in service?
> If you are installing xen and kernel-xen as part of the
kickstart
process and setting kernel-xen
> as the default boot dev, then you would also want to install
kmod-r8168 at the same time and things
> should just take care of themselves.
Yup that is what I was thinking. Unfortunately I don't know how to do
this. I was googling for vmlinuz kernel or cobbler options to help me.
Do you have any suggestions?
As long as you do not require the driver during install time, there
should be no issues. The directions about including kmod-r8168 in the
%packages section should work.
If you need the driver during install time, you will have to rebuild the
initrd that you are using to boot the host via cobbler. This is a much
more involved process that I hope we can avoid, and why I ask the
question above about being able to connect to the network during the
install.
> You will want to make sure you have the repos listed and add
kmod-r8168 to
> the %packages section.
I will do that. But don't I still need to fix grub.conf?
You should not need to modify grub.conf for this to work. As long as
the module is properly packaged, it should get autoloaded when the
hardware is found during the boot process.
--
Scott Henson
Red Hat CIS Operator
WVU Alum BSAE/BSME