Ok, so I've never had selinux enabled. The config is
__BEGIN__ # This file controls the state of SELinux on the system. # SELINUX= can take one of these three values: # enforcing - SELinux security policy is enforced. # permissive - SELinux prints warnings instead of enforcing. # disabled - SELinux is fully disabled. SELINUX=disabled # SELINUXTYPE= type of policy in use. Possible values are: # targeted - Only targeted network daemons are protected. # strict - Full SELinux protection. SELINUXTYPE=targeted __END__
I've got selinux=0 as a boot arg,
so why am I getting this message at boot time??
"Failed to load SELinux policy."
Just started after the update to
Updated: selinux-policy-3.9.16-10.fc15.noarch Updated: selinux-policy-targeted-3.9.16-10.fc15.noarch
thanks.