Hi Frank,
On 24/05/12 14:08 UTC, Frank Murphy wrote:
# dracut initramfs-3.5.0-0.rc0.git3.1.fc18.x86_64
3.5.0-0.rc0.git3.1.fc18.x86_64 F: installkernel failed in module multipat
# rpm -qa | grep multipath device-mapper-multipath-libs-0.4.9-22.fc18.x86_64 device-mapper-multipath-0.4.9-22.fc18.x86_64
I had the same problem, but just on my 32bit Rawhide. Indeed, those two packages (device-mapper-multipath and device-mapper-multipath-libs) were installed on the x86_64 Rawhide.
So, the solution/work-around is simple:
# rpm -e device-mapper-multipath-libs-0.4.9-22.fc18.x86_64 device-mapper-multipath-0.4.9-22.fc18.x86_64
# dracut
That time, the initramfs should be created. Just check that it has been created. For instance:
# ls -l /boot/initramfs-3.5.0-0.rc0.git3.1.fc18.x86_64.img
Then, of course, you have to update the Grub2 configuration, by adding the following lines to /etc/grub2.cfg:
<tab>echo 'Loading initial ramdisk ...' <tab>initrd /initramfs-3.5.0-0.rc0.git3.1.fc18.x86_64.img
Note that, if you do not have a dedicated /boot partition, you should add the /boot prefix in the above line.
That's basically it.
Regards
Denis
On 27/05/12 13:07, Denis Arnaud wrote:
I had the same problem, but just on my 32bit Rawhide. Indeed, those two packages (device-mapper-multipath anddevice-mapper-multipath-libs) were installed on the x86_64 Rawhide.
So, the solution/work-around is simple:
# rpm -edevice-mapper-multipath-libs-0.4.9-22.fc18.x86_64device-mapper-multipath-0.4.9-22.fc18.x86_64
# dracut
Not quite fixed, after removing the device-mapper files. Have updated the bz with the details, also now plymouth and systend-udev problems.