On 06/13/2012 12:03 PM, Adam Williamson wrote:
So it sounds like, right now, what you can do is take an existing bridged config, drop NM_CONTROLLED=no from the ifcfg files, enable the NM service if necessary, and then see if NM takes over properly. It doesn't seem to be explicitly stated, but reading between the lines, the UI stuff isn't done yet.
I just tried this, and NetworkManager didn't bring up either the physical interface or the bridge. Here are ifcfg-eth0 and ifcfg-br0:
DEVICE=eth0 ONBOOT=yes TYPE=Ethernet IPV6INIT=no HWADDR=00:22:4d:4f:c7:ed BRIDGE=br0 #NM_CONTROLLED=no
IPADDR=172.31.250.1 GATEWAY=172.31.250.254 NETMASK=255.255.255.0 DEVICE=br0 ONBOOT=yes TYPE=Bridge IPV6INIT=no DELAY=0 #NM_CONTROLLED=no
Anyone have any ideas?