Ok, so I've never had selinux enabled. The config is
__BEGIN__
# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
# enforcing - SELinux security policy is enforced.
# permissive - SELinux prints warnings instead of enforcing.
# disabled - SELinux is fully disabled.
SELINUX=disabled
# SELINUXTYPE= type of policy in use. Possible values are:
# targeted - Only targeted network daemons are protected.
# strict - Full SELinux protection.
SELINUXTYPE=targeted
__END__
I've got selinux=0 as a boot arg,
so why am I getting this message at boot time??
"Failed to load SELinux policy."
Just started after the update to
Updated: selinux-policy-3.9.16-10.fc15.noarch
Updated: selinux-policy-targeted-3.9.16-10.fc15.noarch
thanks.
--
Brian Millett - [ Sinclair (re: The Line), "The Gathering"]
"The sky was full of stars and every star an exploding ship...one of ours."