Re: Failed to load SELinux policy ????

[Steven Haigh]

On 04/05/2011 03:09 AM, Phil Meyer wrote:
>  On 04/04/2011 09:14 AM, Brian Millett wrote:
> > Ok, so I've never had selinux enabled.  The config is
> >
> > __BEGIN__
> > # This file controls the state of SELinux on the system.
> > # SELINUX= can take one of these three values:
> > #	enforcing - SELinux security policy is enforced.
> > #	permissive - SELinux prints warnings instead of enforcing.
> > #	disabled - SELinux is fully disabled.
> > SELINUX=disabled
> > # SELINUXTYPE= type of policy in use. Possible values are:
> > #	targeted - Only targeted network daemons are protected.
> > #	strict - Full SELinux protection.
> > SELINUXTYPE=targeted
> > __END__
> >
> > I've got selinux=0 as a boot arg,
> >
> > so why am I getting this message at boot time??
> >
> > "Failed to load SELinux policy."
> >
> > Just started after the update to
> >
> > Updated: selinux-policy-3.9.16-10.fc15.noarch
> > Updated: selinux-policy-targeted-3.9.16-10.fc15.noarch
> >
> >
> > thanks.
>  Seeing the same thing here.  Had to add selinux=0 to the boot line to
>  get it to boot at all. 
We're just discussing this in #fedora-qa...

https://bugzilla.redhat.com/show_bug.cgi?id=693410

-- 
Steven Haigh

Email: netwiz(a)crc.id.au
Web: http://www.crc.id.au
Phone: [phone]
Fax: [phone]