Here is something of interest. Tell me if I should post bug report:
I installed severn over the top of RH 9 Shrike
I had to disable my Onboard 1394 Controller on my Asus P4PE mobo to first get past the following error using any install from CD:
"loading sbp2.o"
Just wouldn't go.
Finally installed severn by disabling 1394 onboard in bios.
Now here is the rub.
If I "Enable" 1394 in bios and reboot after install, I get the following messages in sys log: -------------------------------------------------------------------------- Loading sb2p.o module SCSI0: SCSI emulation for IEEE-1394 SBP-2 Devices blk:queue C1993014, I/O limit 4095 mb mask 0xffffffff IEEE1394: sbp2: Logged into SBP-2 device -------------------------------------------------------------------------- And that's where it hangs, dirty shut down required
Go figure??
Here is what lspci shows after clean boot without 1394 on board :
00:00.0 Host bridge: Intel Corp. 82845G/GL [Brookdale-G] Chipset Host Bridge (rev 02) 00:01.0 PCI bridge: Intel Corp. 82845G/GL [Brookdale-G] Chipset AGP Bridge (rev 02) 00:1d.0 USB Controller: Intel Corp. 82801DB USB (Hub #1) (rev 02) 00:1d.1 USB Controller: Intel Corp. 82801DB USB (Hub #2) (rev 02) 00:1d.2 USB Controller: Intel Corp. 82801DB USB (Hub #3) (rev 02) 00:1d.7 USB Controller: Intel Corp. 82801DB USB2 (rev 02) 00:1e.0 PCI bridge: Intel Corp. 82801BA/CA/DB/EB PCI Bridge (rev 82) 00:1f.0 ISA bridge: Intel Corp. 82801DB LPC Interface Controller (rev 02) 00:1f.1 IDE interface: Intel Corp. 82801DB Ultra ATA Storage Controller (rev 02) 00:1f.5 Multimedia audio controller: Intel Corp. 82801DB AC'97 Audio Controller (rev 02) 01:00.0 VGA compatible controller: ATI Technologies Inc Radeon R300 ND [Radeon 9700 Pro] 01:00.1 Display controller: ATI Technologies Inc Radeon R300 [Radeon 9700 Pro] (Secondary) 02:05.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5702 Gigabit Ethernet (rev 02) 02:09.0 FireWire (IEEE 1394): Texas Instruments TSB12LV26 IEEE-1394 Controller (Link) 02:0b.0 Multimedia audio controller: Creative Labs SB Live! EMU10k1 (rev 08) 02:0b.1 Input device controller: Creative Labs SB Live! MIDI/Game Port (rev 08)
Any ideas?
Thanks,
RaXeT
On Fri, 2003-08-15 at 21:49, raxet wrote:
Here is something of interest. Tell me if I should post bug report:
There are already several bugs for this in bugzilla, one of them: https://bugzilla.redhat.com/bugzilla/show_bug.cgi?id=99538
has a workaround, briefly, it consists of: - apply scsi hotplug patch to kernel, you should now be able to boot with 1394 enabled but it won't be detected - after bootup, "modprobe ohci1394", "rescan-scsi-bus.sh" you should be able to see it then.
-
Ben Hsu -
RaXeT