On 06/08/2011 09:32 AM, Tom Hughes wrote:
Works fine for my VMs with bridged networking - they see the radvd on
the network and configure an address.
Tom
Would you care to share some documentation of some kind?
<network>
<name>TheCommons</name>
<uuid>....</uuid>
<forward mode='route'/>
<bridge name='virbr0' stp='off' delay='0' />
<ip address='10.0.1.1' netmask='255.255.255.0'>
</ip>
<ip family='ipv6' address='fd00:xxxx:xxxx:1::1'
prefix='64'>
</ip>
<ip family='ipv6' address='2001:xxxx:xxxx:0::1'
prefix='64'>
</ip>
</network>
That didn't automatically add any of the ipv6 addresses. As I said, no
radvd. If I read the bug reports correctly, it is supposed to be automagic.
Also, the systctl stuff mentioned in the bugs reports I mentioned were
set to not allow ipv6, etc. Did you override these defaults somewhere?
Thank you,
Trever