On Mon, Mar 22, 2004 at 09:23:27AM +0100, Tony Grant wrote:
The install went fine up till the end where it hung on
"finishing..."
(as the install was done in French I don't have the english text). The
only issue was the video card wasn't recognised so vesa driver was used.
That is correct
OK so reset and... nothing. No BIOS screen, no hard disk activity.
The
only things showing any life were the two CD-ROM drives which were
getting power.
Power off - power on nothing the machine is dead.
Any clues? Coincidence or "something bad happened during install" TM?
Try unplugging the IDE disks see what it does. Some K6 BIOSes will choke
with large hard disks (>32G), and sometimes it matters whether there is
a partition table present or not .
You hang sounds a bit early for that however