Hi all ;
I've installed vpnc on Fedora 10
I have a cisco connection on a mac that works fine.
I've tried to re-create in a vpnc config file like this (I replaced the values for security):
IPSec gateway 1.2.3.4 IPSec ID custname IKE Authmode psk IPSec secret psk_secret # your username goes here: Xauth username assigned_username
I always get this response: Enter password for assigned_username@1.2.3.4: vpnc: no response from target
Can anyone help me debug this ?
Thanks in advance
On Tue, Dec 02, 2008 at 08:14:06PM -0700, Kevin Kempter wrote:
Hi all ;
I've installed vpnc on Fedora 10
I have a cisco connection on a mac that works fine.
I've tried to re-create in a vpnc config file like this (I replaced the values for security):
IPSec gateway 1.2.3.4 IPSec ID custname IKE Authmode psk IPSec secret psk_secret # your username goes here: Xauth username assigned_username
I always get this response: Enter password for assigned_username@1.2.3.4: vpnc: no response from target
Can anyone help me debug this ?
If you have a Cisco .PCF file for this connection, you can convert it into a vpnc configuration file with the "pcf2vpnc" utility that is part of the vpnc distribution.
I don't know if pcf2vpnc is part of the vpnc rpm that comes with F10 or not, though I suspect it may not be. But I got the impression from your posting that you had built vpnc from source yourself??? if so, you should have that tool.
If that doesn't help you, you may want to look into firewall rules that may be blocking the vpn, etc.
Kevin Kempter wrote:
Hi all ;
I've installed vpnc on Fedora 10
I have a cisco connection on a mac that works fine.
I've tried to re-create in a vpnc config file like this (I replaced the values for security):
IPSec gateway 1.2.3.4 IPSec ID custname IKE Authmode psk IPSec secret psk_secret # your username goes here: Xauth username assigned_username
I always get this response: Enter password for assigned_username@1.2.3.4: vpnc: no response from target
Can anyone help me debug this ?
Looks like a firewall setting. Make sure your iptables is set up to accept the various protocols. I have these rules:
# Protocol 50 is for encapsulated security payload... -A RH-Firewall-1-INPUT -p 50 -j ACCEPT # Protocol 51 is for authentication headers... -A RH-Firewall-1-INPUT -p 51 -j ACCEPT
Test first by disabling your firewall ("service iptables stop"), and trying the connection again. If it works, then use your favorite firewall tailoring tool to put in those rules and try again. ---------------------------------------------------------------------- - Rick Stevens, Systems Engineer ricks@nerd.com - - AIM/Skype: therps2 ICQ: 22643734 Yahoo: origrps2 - - - - I don't suffer from insanity...I enjoy every minute of it! - ----------------------------------------------------------------------