On Thu, 2009-07-02 at 18:48 -0400, Andre Robatino wrote:
-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1
On 07/02/2009 06:06 PM, Frank Cox wrote:
On Thu, 02 Jul 2009 17:21:13 -0400 Andre Robatino wrote:
is there a walkthrough anywhere on how to make the resulting system usable?
yum grouplist
Pick the groups you want to install, then
yum groupinstall "name of group" "name of another group"
And so on.
Good, that sounds not too difficult. Of course, it assumes that networking is working. Does anyone know how this is done after a text-based install? "ifup eth0" didn't work.
If you are using NetworkManager you turn the internet on by choosing the eth0 option in the nm-applet in the upper right corner of the panel.
If you are running network then use system-config-network and configure the eth0 interface, That is thew same as choosing the System->Administration->Network option
Find out which you are running by using the : chkconfig --list |grep <program name>
Only one should be running. I would expect by default it is NM. -- ======================================================================= Don't suspect your friends -- turn them in! -- "Brazil" ======================================================================= Aaron Konstam telephone: (210) 656-0355 e-mail: akonstam@sbcglobal.net