On Wed, Feb 22, 2006 at 02:09:26PM -0600, Mike McCarty wrote:
I have an HP870Cse, which I'm sure you are all getting tired
of hearing about. I have three queues set up for that printer,
one at 300dpi greyscale (default), one at 600dpi greyscale,
and one which is two up 300dpi greyscale (color cartidges are
just too expensive, IMO). Each of these is set up in the
GNOME Print Mangager for pre-rendering, since the postscript
interpreter on that printer is S-L-O-W (like 30 minutes per page)
while transferring a graphics image is acceptably fast (like 4 pages
per minute).
I assume by the Gnome Print Manager you mean system-config-printer.
This program just does not work properly in a CUPS environment.
Set up your printer using the CUPS web interface
and I think you will find the results will be more to your liking.
But I find that only the first two actually honor the pre-rendering.
If I print to TwoUp, then it does indeed print two pages side-
by-side on the page, but it takes 30 minutes. If I use mpage,
I get 4 pages per minute again.
Is anyone aware of why that would be or what I could do to
correct that?
Also, I'd like to do some two-sided printing. This printer does
not have a duplexer, so I've been investigating using mpage or
psmandup for that. Does anyone have experience using these
in this manner automatically by setting up the queue to use
them directly?
Mike
--
p="p=%c%s%c;main(){printf(p,34,p,34);}";main(){printf(p,34,p,34);}
This message made from 100% recycled bits.
You have found the bank of Larn.
I can explain it for you, but I can't understand it for you.
I speak only for myself, and I am unanimous in that!
--
fedora-list mailing list
fedora-list(a)redhat.com
To unsubscribe:
https://www.redhat.com/mailman/listinfo/fedora-list
--
=======================================================================
You have the capacity to learn from mistakes. You'll learn a lot today.
-------------------------------------------
Aaron Konstam
Computer Science
Trinity University
telephone: (210)-999-7484