On 01/24/2013 10:10 AM, Patrick O'Callaghan wrote:
On Wed, 2013-01-23 at 18:48 -0700, Ryan Rix wrote:
> You can set per-network firewall settings in the Edit Connection dialog of the
> network manager applet.
[Please don't top-post on this list]
I see the dialogue, but it's not nearly flexible enough. For example,
there's no obvious way of allowing access to a given port (service)
which is one of the most basic requirements of firewall configuration.
I could be wrong.... But what I think Ryan was trying to convey was that for each
connection (a.k.a. Interface) you could assign a firewalld zone and then configure that
zone as you wish for all the services you want to allow.
Yes, you have to use 2 Tools. One being "firewall-config"
--
Programming today is a race between software engineers striving to build bigger and better
idiot-proof programs, and the Universe trying to produce bigger and better idiots. So far,
the Universe is winning. -- Rick Cook, The Wizardry Compiled